Model MTC-4004  

NEW 4th Generation V 4.0

        Start and stop probe assemblies are mounted at

2 different areas on the pasteurization holding tube.  The

top of the SSI-003 salt injector is attached to a pressurized

air source while the bottom is attached to the start probe

injection nozzle with high pressure reinforced tubing.

        Once the SSI-001 liquid output valve is manually

opened,  saline solution is injected into the holding tube

which starts the counter.  When the saline solution reaches

the stop probe,  the counter stops providing the elapsed

time.  The operator can then run additional tests to satisfy

the health code.

1)  MTC - 4004 hand held battery operated milk tester control with

     auto - calibration/equalization, USB PC interface, battery charger

     cable,  and protective carrier

2)  2 - Type 2DCF1.5" tri-clamp Sanitrodes™ (probe assemblies) with

     two 4" long teflon insulated probe

3)  2 - Type 2DCF2" tri-clamp Sanitrodes™ (probe assemblies) with

     two 4" long teflon insulated probes (alternate

           tri-clampsizes available (2.5", 3" or 4" caps))

***For alternate probe cap types please consult Lumenite®.

4)  2 - Type 2J1.5" jack with 10 feet of cable (probe to tester connection)

• SSI-003 304 s.s. constructed saline solution injection apparatus

• Type .25 x .25 3-4 s.s. check valves

• Type 10ft. of reinforced tubing with fitting for connection to SSI-003

• Universal USB car charger for MTC-4004

• Carrying case designed to hold the MTC-4004, 6 Sanitrodes™,  2 jacks and various other accessories

•  Spray Nozzle for Start Probe (used for connection to SSI injector)

•  Additional Start and Stop probes can be purchased as needed

•  Additional 2J-1.5" milk tester jacks